A disconnected battery can disrupt a vehicle’s transmission performance. If your 2015 Ford requires a transmission reset after battery disconnection, a 2015 Ford Scan Tool is essential. This article outlines the procedures to reset the transmission adaptive tables using a compatible scan tool. While these instructions refer to a 2019 Nautilus, the general principles apply to similar Ford models, including the 2015 Ford. Consult your vehicle’s specific workshop manual for precise instructions.
Understanding Transmission Adaptive Tables
Modern vehicles like the 2015 Ford utilize adaptive learning for transmission control. These systems monitor driving habits and adjust shift points, engagement, and overall performance for optimal fuel economy and drivability. Disconnecting the battery can erase these learned values, resulting in harsh shifts or unusual transmission behavior. A 2015 Ford scan tool allows you to clear these tables and initiate a relearning process.
Adaptive Learning Drive Cycle Reset Procedure
This procedure, utilizing a 2015 Ford scan tool, helps the transmission relearn optimal shift patterns.
Prerequisites:
- 2015 Ford Scan Tool: A compatible scan tool is required to clear Diagnostic Trouble Codes (DTCs) and reset the Transmission Adaptive Tables.
- Operating Temperature: Ensure the engine and transmission have reached normal operating temperature before beginning.
Steps:
-
Clear DTCs and Tables: Using your 2015 Ford scan tool, clear any existing DTCs and the Transmission Adaptive Tables.
-
Gear Selection Sequence: With the engine running and the brake applied, shift through the gears in the following sequence, pausing for 4 seconds in each gear: Neutral, Reverse, Neutral, Drive, Reverse, Drive, Neutral. Repeat this pattern twice. If shifts feel harsh or soft, repeat the sequence.
-
Moderate Acceleration/Braking: Drive the vehicle, accelerating moderately to achieve upshifts at 2,000 RPM up to 60 mph. Then, brake moderately to a complete stop. Repeat this process twice.
-
Higher RPM Acceleration/Braking: Repeat step 3, but aim for upshifts at 3,000 RPM.
-
Repeat Gear Selection: Repeat the gear selection sequence from step 2.
Road Testing and Shift Point Verification
After the reset, perform a road test to verify proper transmission operation.
Steps:
-
Warm-up: Ensure the engine and transmission are at normal operating temperature.
-
Drive in “D”: Operate the vehicle in Drive (D).
-
2,000 RPM Acceleration: Accelerate from a stop to 50 mph, aiming for upshifts at approximately 2,000 RPM. Maintain 8th gear (if applicable) for 30 seconds or until the Torque Converter Clutch (TCC) engages. Repeat twice.
-
3,000 RPM Acceleration: Repeat step 3, aiming for upshifts at approximately 3,000 RPM.
Conclusion
Using a 2015 Ford scan tool to reset the transmission adaptive tables is often necessary after a battery disconnection. These procedures allow the transmission to relearn and optimize its performance. If problems persist, consult a qualified automotive technician for further diagnosis and repair. Remember to always consult your vehicle’s specific workshop manual for accurate procedures.
