Reversing cameras are invaluable for safe and convenient parking, especially in vehicles like the Audi R8. If your rearview camera needs calibration, VCDS (Vag-Com Diagnostic System) can be a powerful tool. This guide, drawing insights from various forums like Audizine and R8talk, offers a step-by-step approach to calibrating your Audi R8’s reversing camera using VCDS.
Understanding the Calibration Process with VCDS
Calibrating your reversing camera involves adjusting its settings within the car’s control module using VCDS. This process requires precise measurements and inputs to ensure accuracy. A key component is a large-format printed calibration chart, ensuring correct dimensions for the calibration process. Sources like FedEx/Kinkos often offer large format printing services.
Step-by-Step VCDS Calibration Guide
This guide outlines the successful calibration process shared by Audi enthusiasts on online forums, specifically for an Audi A4 (B8.5), but the general principles apply to the Audi R8. Remember to consult your R8’s specific documentation for any model-specific adjustments.
Preparing for Calibration
-
Print the Calibration Chart: Obtain a properly scaled calibration chart. Accuracy is crucial, so professional printing is recommended.
-
Precise Positioning: Place the chart precisely 51.5 inches behind the center of your rear wheel. This distance is critical for accurate calibration. Ensure the ground is level.
VCDS Adaptation
-
Access Backup Camera Module: Connect your VCDS interface and select module [6C – Back-Up Camera].
-
Enable Adaptation: Enter Security Access code 22351 to enable adaptation changes.
-
Adjust Adaptation Channels: Navigate to [Adaptation – 10] and modify the following channels:
-
Channel 005: Enter a value corresponding to the chart’s height from the ground. In the example, 500 was used for a chart placed on the ground. [Read], [Test], [Save].
-
Channel 004: Calculate the value using the formula: 20000 (base measure) – axle width – distance from rear wheel. For the A4 example: 20000 – 2820 – 1308 = 15872mm. Substitute your R8’s specific axle width. [Read], [Test], [Save].
-
Channel 001: Enter a value of 1 to initiate the calibration process. [Read], [Test], [Save].
-
Exit Adaptation: Select [Done, Go Back].
-
Verification
-
Check Calibration Status: Go to [Meas. Blocks – 08], select Block 130, and check Field 3 (Calibration Status). A value of 0x0000 indicates successful calibration.
-
Scan for Fault Codes: Scan for any fault codes related to the backup camera. If errors persist, double-check your measurements and repeat the process. If problems continue, consult the forums or a qualified technician.
Conclusion
Successfully calibrating your Audi R8’s reversing camera using VCDS requires precision and attention to detail. While this guide provides a framework based on shared forum experiences, always refer to your vehicle’s official documentation for specific instructions. Utilizing online forums like R8talk and Audizine provides a valuable resource for troubleshooting and community support. Remember, accurate calibration enhances safety and driving experience.
