This guide outlines the process and potential challenges of enabling cruise control in a 2005 Volkswagen Transporter using VCDS (Vag-Com Diagnostic System). We’ll explore the necessary steps, common error codes, and provide insights into successful coding procedures.
Understanding the VCDS Cruise Control Coding Process
The owner of a 2005 VW Transporter aims to activate cruise control using a HEX+CAN VCDS interface. The vehicle is equipped with an Engine Control Module (ECM) with part number 070 906 016 BD and a Central Electronics Module (CEM) with part number 7H0 937 049 K. Initial attempts to code both modules have encountered difficulties. While the online resources suggest the CEM supports cruise control, the module’s Long Coding Helper doesn’t explicitly mention it. Attempts to code the ECM resulted in “Error 22 – Conditions not correct or request sequence error.” This error often indicates an issue with coding prerequisites, incorrect coding procedures, or incompatibility.
Decoding Error 22 in VCDS Cruise Control Coding
Error 22 in VCDS signifies a problem with the coding attempt. Several factors can contribute to this error:
- Incorrect Coding Procedure: The specific steps for activating cruise control can vary depending on the vehicle’s model year, engine code, and installed modules. Deviations from the correct procedure often lead to Error 22.
- Missing Prerequisites: Certain conditions must be met before cruise control can be activated. This might include the presence of specific hardware components (e.g., cruise control stalk, clutch/brake switches) and their correct installation and functioning.
- Incompatible Hardware or Software: In some cases, the vehicle’s hardware or software version may not support cruise control. This is less likely in a 2005 Transporter, but it’s worth verifying compatibility using the VCDS system and official resources.
Troubleshooting VCDS Cruise Control Coding on a 2005 VW Transporter
Given the encountered issues, the following steps are recommended:
-
Verify Hardware: Ensure the Transporter is equipped with the necessary cruise control hardware, including the steering wheel stalk with cruise control buttons and properly functioning clutch and brake pedal switches.
-
Consult Official Resources: Refer to the official Ross-Tech VCDS website (www.Ross-Tech.com) and their extensive wiki for detailed coding instructions specific to the 2005 VW Transporter with the specified engine and CEM part numbers.
-
Check for Fault Codes: While the initial scan didn’t reveal relevant fault codes in the ECM or CEM, it’s crucial to address the fault code present in the ABS module (Address 03). A faulty wheel speed sensor might indirectly affect cruise control functionality. Resolve this issue before proceeding with cruise control coding.
-
Analyze Long Coding Helper: Carefully examine the Long Coding Helper within VCDS for both the ECM and CEM. While cruise control may not be explicitly mentioned, look for options related to “speed regulation,” “GRA” (Geschwindigkeitsregelanlage, the German term for cruise control), or similar functionalities.
-
Seek Expert Assistance: If the problem persists, consider contacting Ross-Tech directly or consulting with a qualified VW technician experienced in VCDS coding. They can provide tailored guidance based on your specific vehicle configuration.
Conclusion: Successfully Enabling Cruise Control with VCDS
Enabling cruise control in a 2005 VW Transporter with VCDS requires careful attention to detail and a methodical approach. By verifying hardware, consulting official resources, resolving existing fault codes, and meticulously examining the Long Coding Helper, you significantly increase the chances of successful coding. If challenges persist, seeking expert assistance from Ross-Tech or a qualified technician is recommended. Remember to always back up your original coding before making any changes.
