Activating and troubleshooting Lane Departure Warning, also known as Active Lane Assist, on a 2015 Audi A6 facelift can be challenging. This article will guide you through the process of locating the relevant module within VCDS and understanding common coding issues. The focus will be on addressing the specific problem of enabling Active Lane Assist while resolving conflicts with other systems like Side Assist.
Understanding the VCDS System and Lane Assist Modules
VCDS (Vag-Com Diagnostic System) allows access to the various control modules within your Audi. To find the settings for Lane Departure Warning, you need to access the Image Processing module (address 8E). This module, often referred to as the BV-SG, is responsible for processing camera data and managing features like Lane Assist and Lane Change Assist. Within this module, Byte 1 is crucial for configuring these features.
Common Coding Issues and Solutions
A common issue when enabling Active Lane Assist (ALA) is a conflict with the Side Assist system. The VCDS coding options for Byte 1 in module 8E usually offer choices for enabling different combinations of ALA and Side Assist:
- Coding 20: Typically designates Side Assist as “not installed.” This option often results in a stable display but disables steering assistance for ALA, and adaptation attempts are rejected.
- Coding 40: Often enables both Lane Assist and Lane Change Assist. This may cause display flickering, missing messages (likely related to Side Assist conflicts), but steering assistance for ALA might function.
The problem arises when the car’s physical hardware and installed systems don’t match the selected coding. For instance, if the vehicle has ALA but not Side Assist, using Coding 40 might lead to errors.
Troubleshooting Steps:
-
Verify Hardware: Confirm the presence of the front camera and any relevant sensors for both ALA and Side Assist on your A6. Consult your vehicle’s documentation or a trusted Audi specialist.
-
Check Fault Codes: Before making coding changes, scan for fault codes in module 8E (Image Processing) and related modules like address 17 (Instruments). Address any existing faults before proceeding. Common fault codes like U1111 (Function Restricted due to Missing Message(s)) often indicate communication errors between modules.
-
Coding Adjustments: Carefully adjust Byte 1 in module 8E. If Coding 40 generates errors, try Coding 20 or other relevant coding options based on your vehicle’s specific equipment.
-
Adaptation: After changing the coding, attempt adaptation within module 8E to activate ALA. If rejected, review the fault codes for clues.
-
MMI Settings: Ensure that the MMI (Multi Media Interface) settings correctly reflect the desired Lane Assist configuration. Incorrect submenus may indicate a coding mismatch.
Conclusion: Achieving a Functional Active Lane Assist System
Successfully enabling Active Lane Assist on a 2015 Audi A6 using VCDS requires a thorough understanding of the involved modules and coding options. Addressing any underlying hardware or communication issues is crucial. By carefully reviewing fault codes, adjusting coding in the Image Processing module (8E), and ensuring proper MMI configuration, you can increase your chances of achieving a fully functional Lane Departure Warning system. Remember to consult official Audi documentation or a qualified technician for complex issues.
